Paint Repair UV
Step 8
Dry the surface with a UV lamp for 4 minutes. (UV-A lamp light wavelength 365-395 nm).
Step 9
After polishing, finished lacquer repair.
Step 1
Sand the damaged area, then clean with silicone remover. Apply plastic adhesion promoter.
Step 2
Shake up UV Primer, apply with approx. 1-2 sprays (40-50 µm), then flash-off for approx. 1 minute.
Step 3
Dry UV Primer with UV lamp for 4 minutes. (UV-A lamp light wavelength 365-395 nm).
Step 4
After drying, remove any adhesive film that may have formed with special UV cleaner, sand the surface, matte the edge zones.
Step 5
Apply the basecoat in 2-3 coats. Air dry.
Step 6
Apply 1-2 coats of UV clear with intermediate exhaust air. Allow 1 minute flash time between coats.
Step 7
Immediately after the UV clearcoat, apply UV Blender over the clear including edge areas. Allow to flash off for 1 minute.
Step 8
Dry the surface with a UV lamp for 4 minutes. (UV-A lamp light wavelength 365-395 nm).
Step 9
After polishing, finished lacquer repair.
Step 1
Sand the damaged area, then clean with silicone remover. Apply plastic adhesion promoter.
Step 2
Shake up UV Primer, apply with approx. 1-2 sprays (40-50 µm), then flash-off for approx. 1 minute.
Step 3
Dry UV Primer with UV lamp for 4 minutes. (UV-A lamp light wavelength 365-395 nm).
Step 4
After drying, remove any adhesive film that may have formed with special UV cleaner, sand the surface, matte the edge zones.
Step 5
Apply the basecoat in 2-3 coats. Air dry.
Step 6
Apply 1-2 coats of UV clear with intermediate exhaust air. Allow 1 minute flash time between coats.
Step 7
Immediately after the UV clearcoat, apply UV Blender over the clear including edge areas. Allow to flash off for 1 minute.
Step 8
Dry the surface with a UV lamp for 4 minutes. (UV-A lamp light wavelength 365-395 nm).
Step 9
After polishing, finished lacquer repair.
