OEM

Special products for application on production lines

The speed on the conveyor belt determines the cycles of the individual production stations and therefore the time and the possibilities to carry out reworking. If this is not possible directly on the production line, the parts or vehicles need to be separated in a time-consuming process. Therefore, the following factors are important: immediate readiness, even within the cycle times, targeted application, even in difficult-to-access corners and edges, low overspray and misting, and absolute compliance with the original line products that were used.

Application areas

KTL

KTL-reworking on typical places, depending on the car body form, immersion and KTL flow behaviour.

Filler station

Filler reworking, depending on the filler application type, car body type and wetting possibilities.